|
CyberVision64/3D The Cybervision64/3D screen stays plain black or grey. Cause: Make sure that you have the Monitor hooked up to the proper connector on the Cybervision64/3D card and not to the 23 pin Amiga video port. While using the Scandoubler, make sure that the monitor is connected properly to the VGA connector of the Scandoubler module, and not to the 23 pin Amiga standart port. The original Amiga video connector is not able to provide the signal comming from the Cybervision64/3D. Also defective cables and/or connectors may be the cause. Solution: Connect your monitor to the Cybervision64/3D or in case of a scandoubler to the scandoubler. While using the scandoubler, please make sure that the scandoubler is properly connected to the Cybervision64/3D and that the cable connection between scandoubler and Cybervision64/3D are properly connected. Otherwise connect the scandoubler correctly to the Cybervivsion64/3D and make sure, that the cable between the Cybervision64/3D and the scandoubler is in place. Also make sure that all the cables and connectors are working properly and that none of them are defective. Replace them if necesary.
|